puppetx

Shouldn’t the text read something like, “republicans looking at the receipts for the wall Mexico was supposed to pay for”

A version of this. https://en.m.wikipedia.org/wiki/Missing_square_puzzle

As a fan of Bernie this fantastic news, I want to hug the scroll if it can be corroborated.

Found the night owl!

As a child of the 80s I liked the 3rd one better.

Our population is shrinking, what should we do!? I know, let’s enact policy that encourages people to leave!

WTF!?

Tom Stanton already did this!

https://youtu.be/P5uUyUWpP_I?si=Bn40TnmDH3UVR-yf

I run a pie hole, it has a lot of meta/facebook subdomains blocked. I would recommend that as a simpler potential solution than flashing custom firmware.

Hold on, gotta check with my pundits to see if I should be outraged about this or not…

"nobody drives in New York, there's too much traffic".

I've been told it's going to trickle down any moment now...

In prusa slicer after you click slice you will be presented with your sliced gcode. At this point you can use the vertical scroll bar on the right (to pick a layer), and the horizontal scroll bar on the bottom (to play through the tool path (moves) for that layer) to see every operation your printer is going to perform as it runs this gcode.

If this was somehow caused by bad slicing/g-code it could be used to help troubleshoot it. But it sounds like others here have probably provided more insightful troubleshooting suggestions and you may want to pursue their advice first. Hopefully your tightened z screw solves the problem!