Ah, I realise my wording was very confusing there. I meant: Because the inductor is NOT the problem - I don't have any idea what the problem is - therefore the LAPTOP is dead (not the inductor)๐
That's a great tip, but unfortunately the power supply is not turning off. I will refer to this next time though ๐
Current passes through it unfortunately, maybe it's possible there is a short between coils though. The inductor doesn't get hot or anything when plugged in.
Even if I don't manage to fix it. Thanks for the suggestions ๐
Great advice, but unfortunately I've checked. 20V from the supply (measured on the laptop PCB), everything removed except the ram because I only have one compatible stick - I did swap the slot though.
Just the continuity test ๐
Thanks. I guess I was just hoping it would be an easy find and fix. The beep confirmed hope is lost ๐ฅฒ
I tried to start my laptop earlier, only for nothing to happen. It won't start on battery or when plugged in (it can run without a battery when plugged in). The battery does seem to be dead, and so is the 3V CMOS battery.
I opened it up and noticed a circle visable on one of the inductors. Hopefully you can see it in the picture.
Could this be the problem, or is that normal?
I've never visited the site before so I just assumed it was just malicious, but as @zdanger said, it might be a hijacked legit site.
I do use uBlock. It also didn't 'feel' like an ad. I now expect the site was compromised as you suggested.
Thanks for that. I also didn't know about that shortcut until now. It will be very helpful ๐๐
I can't actually make it copy ๐ I've now also tried in Firefox and Chrome but it still hasn't worked.
Thanks, that's very interesting to know. I assumed it was just a malicious site before.
motorandwheels(dot)com
I've also noticed, it doesn't always come up but let me know if it does for you.
I just saw this and felt I should share it. I'm sure most people here wouldn't fall for it but it can't hurt to make sure ๐
Edit: I just wanted to add, I have no idea what this tried to copy. I'm using Firefox on Linux which is perhaps why it didn't make it to my clipboard ๐คท
Can anyone tell me what these yellow exclamation marks mean?
When I do an overhang test, I always have this problem at about 35ยฐ. Does anyone have a suggestion what could be causing it?
Solution: I mistakenly thought overhang speed in Orca was based on overhang angle, it is percentage instead (which makes much more sense for different layer heights). My 10-25% overhang speed wasn't set to slow down and that must translate to about 35ยฐ at 0.2mm layer height. I now have it set to 30mm/s and it now looks great ๐ And sorry, I was wrong when I stated the overhang speed ๐
Can anyone suggest what causes these lines across the page?
Is a new toner cartridge likely to fix this?
Edit: Line separation is 62.5mm
Edit 2: Thank you to everyone who replied. I've ordered a new toner cartridge and will update this if that solves the problem ๐ซก
Final update: A new toner cartridge fixed it. It's now printing perfectly! Thank you.
Nope, no signs of life with the battery removed and on wall power only. I believe the battery was not to blame, but something went wrong that caused it to also drain the battery. I will check the battery anyway and report back if I find anything interesting. Thanks for the helpful link.