overview for PixeIOrange

How did you get back there? in c/[email protected]

[–] [email protected] 4 points 2 years ago

Toes and fingers are still in the cage! Technically shes in the cage! To about 1%! Not guilty!

Sleepy teefies in c/[email protected]

[–] [email protected] 6 points 2 years ago

Just 5 more hours...

ich🦷iel in c/[email protected]

[–] [email protected] 5 points 2 years ago

Er hat sein Gebiss verloren...

Gatze Bauchi kraulen! in c/[email protected]

[–] [email protected] 27 points 2 years ago

Es ist eine Falle! Eine weiche, flauschige, gestreifte Falle!

ich🤮iel in c/[email protected]

[–] [email protected] 12 points 2 years ago

Arme Flügelratte :(

First mm always faulty? in c/[email protected]

[–] [email protected] 2 points 2 years ago (2 children)

It does the same priming lines, im using the same start gcode. Without it would miss the complete first half of the gears outter wall, oftem from the 5 lines only 3 get printed.

First mm always faulty? in c/[email protected]

[–] [email protected] 1 points 2 years ago

In PrusaSlicer externals first, in cura outside to inside. Whats weird in cura, it prints the outter wall ls first half gears first, then the spokes from the second half.

Ich sehe keinerlei Nachteile in c/[email protected]

[–] [email protected] 3 points 2 years ago

Die Bild ist halt bekannt dafür, diese Bindestriche gerne in ihren Überschriften zu verwenden. Wirkt immer etwas infantil. Passend zur Leserschaft.

First mm always faulty? in c/[email protected]

[–] [email protected] 2 points 2 years ago

Should be a slicer problem, with cura its gone...

First mm always faulty? in c/[email protected]

[–] [email protected] 3 points 2 years ago (1 children)

Thanks for your offer. I tried cura slicer and there the problem is gone. So it is a problem in PrusaSlicer. Here is the gcode, please dont put too much effort into it.

https://filetransfer.io/data-package/i7JoxlFl#link

First mm always faulty? in c/[email protected]

[–] [email protected] 3 points 2 years ago

Its a slicer error. With cura it works correct...

First mm always faulty? in c/[email protected]

[–] [email protected] 3 points 2 years ago (6 children)

I changed every retraction setting ive found. 2x in PrusaSlicer, 1x on Klipper, nothing changes. But with Cura Slicer the problem is gone. So i obviously f*ed up some setting in PrusaSlicer. Will test more today.