Mayhaps
KyuubiNoKitsune
joined 2 years ago
I'll try my best but it'll probably be wrongish.
It usually relates to a notable thing happening in a closed community or specific subject.
There was PM spam from "the fediverse chick" a while ago, and that became the Lemmy meta for a bit.
Thanks for proving my point.
I stopped using it for 3 years, then I had to interact with a surgeon through it and reconnected with a fee people who still use it. I fucking hate using it
Reddit and Discord killed that, sorry, the Internet you're referring to is dying and almost dead.
You clearly have absolutely no idea what infrastructure costs to run.
Ah fuck, mines stale. Wonder if I can rejuvenate it by popping it in the oven for a few min.
Two ideas? In this economy?
Someone left their NAT Gateway running..
Scream and cry I recon
I think they'll get a promotion for this one
-37
If "I'm" is the contraction of "I am", then "I'm baby" is a contraction of "I am baby"
(lemmy.blahaj.zone)
Hi,
I'm looking for some help in a field that is super technical and I don't fully understand.
I'm planning on using a bunch of these seeed studio Esp modules for some home automation projects, especially because they have a lipo battery charger making it great for portable stuff.
The thing is the the ESP32s have U.FL SMD antenna connectors. Most of the antennas that you can buy with U.FL connections while are reasonably small, come with 50-150mm leads, which sort of makes the small size of the module a little less valid.
What I'd like to do is get a female U.FL SMD connector and make a small daugherboard with an 2.4GHz SMD antenna on it, for instance a Janson 2450AT42B100 or a Molex 479480001.
They go over the circuit board requirements quite thoroughly so I don't think designing it will be too difficult, but what I don't know is, they say that you need impedance matching on the circuit, and I see that there appears to be something that looks like it on the ESP circuit diagram, but I'm not actually sure if it is or not:
You can see it in the middle near the bottom of the diagram here: Seeeduino-XIAO-ESP32C3-SCH
So my questions are:
1: Is this a dumb idea, having a direct plug-on SMD antenna?
2: Is that an impedance matchning circuit between LNA_IN on the ESP chip and U.FL-R-SMT-1?
3: If I can't get a female U.FL SMD connector, would using one with a lead and shortening it to make the daughterboard able to be much closer to the connector affect anything? Do I need to ensure that the lead length matches the wavelength at all?
Edit: Found this SMD female U.FL, so they do exist.
view more: next ›
Perhaps