Does anyone else have problems uploading images?
I can't upload images in posts or comments, I just get "Could not upload image"
Device information
Sync version: v23.09.13-18:19
Sync flavor: googlePlay
Ultra user: false
View type: Slides
Push enabled: false
Device: raven
Model: Google Pixel 6 Pro
Android: 14
Small caveat, not available on latest version of Android
Oh trust me, I'm slowly working up my collection but the storage cost alone is more than that
Every year Hulu offers 12 months for $12
Always hard to pass that one up.
How do you go about getting invited to a private tracker?
I seed all my Linux isos on public trackers but I'm not active in any communities
Will an owl show up someday with a letter?
But there are a lot of other things that do 👈😎👈
I am heating before I level, I've spent many many hours on it today and finally got something
Depending on how it goes when this print finishes I might switch back to the springs
The S1 comes with a CR Touch already installed, still have the problem
I'll give this a shot, I was under the impression that you start with them as uncompressed as possible
That's what I was wondering, it's a pretty large print taking up most of the build plate. Since the bed is magnetic it takes a little bit of work to get it off
The bed is completely heating before each print, I just about always let it preheat and do something else before I start the print
It is not enclosed, would that make that much of a difference? I'm talking like one print turns out great for the entire duration and then I go to print again and the first layer won't even stick.
Not sure what you're even asking with the other questions about slop, backlash, and z tilt. Will have to look into those
Ah, thanks for the info!