this post was submitted on 01 Jul 2023
10 points (100.0% liked)

homeassistant

15200 readers
2 users here now

Home Assistant is open source home automation that puts local control and privacy first.
Powered by a worldwide community of tinkerers and DIY enthusiasts.

Home Assistant can be self-installed on ProxMox, Raspberry Pi, or even purchased pre-installed: Home Assistant: Installation

Discussion of Home-Assistant adjacent topics is absolutely fine, within reason.
If you're not sure, DM @[email protected]

founded 2 years ago
MODERATORS
[email protected]
[email protected]
10
Led controller for segmented led (lemmy.world)
submitted 2 years ago by [email protected] to c/[email protected]
20 comments fedilink hide all child comments
 

So i bought a floor lamp, similer to the hue signe lamp, its segmented but i dont know if wled would be a good option for it or what controller would be a good option, it has 4 pins

you are viewing a single comment's thread
view the rest of the comments
[–] [email protected] 1 points 2 years ago (1 children)

You can start with the Dig Uno if you want expandability, or you could get a dig2go and just use a usb-c power supply

[–] [email protected] 1 points 2 years ago (1 children)

But it looks like the dig2go only uses 3 wires

[–] [email protected] 1 points 2 years ago* (last edited 2 years ago)

And it's only 5V IIRC. Your lights may be 12V (check the power supply). Honestly you can just run it off a bare ESP8266 or ESP32 dev board without the Dig shield if you want to try it out without spending a bunch up front.