Kid's gotta learn the tricks of the trade somehow
this post was submitted on 29 Aug 2023
107 points (94.2% liked)
Machinist
1028 readers
1 users here now
From Newcomers to Old Timers, a community united by the Industry of Machining
Rules Don't post illegal stuff
Don't post Porn (no sexy aluminum surface finishes don't count)
Don't be an asshat (harassment, bullying etc.)
If you're going to post NSFW stuff, flag it as NSFW, It's ok to post shop Screwups (blood/cuts) just make sure to flag it as NSFW
and Finally make sure to have a good time :D
founded 2 years ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
It's almost entirely a joke, but I also legitimately get parts that are physically impossible to control inside any of the designed tolerances because of the quality of raw stock. Garbage in, garbage out and all that.