3DPrinting
3DPrinting is a place where makers of all skill levels and walks of life can learn about and discuss 3D printing and development of 3D printed parts and devices.
The r/functionalprint community is now located at: or [email protected]
There are CAD communities available at: [email protected] or [email protected]
Rules
-
No bigotry - including racism, sexism, ableism, homophobia, transphobia, or xenophobia. Code of Conduct.
-
Be respectful, especially when disagreeing. Everyone should feel welcome here.
-
No porn (NSFW prints are acceptable but must be marked NSFW)
-
No Ads / Spamming / Guerrilla Marketing
-
Do not create links to reddit
-
If you see an issue please flag it
-
No guns
-
No injury gore posts
If you need an easy way to host pictures, https://catbox.moe/ may be an option. Be ethical about what you post and donate if you are able or use this a lot. It is just an individual hosting content, not a company. The image embedding syntax for Lemmy is 
Moderation policy: Light, mostly invisible
view the rest of the comments
It is just a wire and connector. That isn't Prusa. If it was a bambu you would be buying a new printer without an upgrade path, and since a new printer came out, your old suddenly stops working right like some Apple product. Believe it or not, bambu printers have connectors, likely from the same global supplier too.
The quick fix is to remove the connector from both sides, yes the female too. Then solder the connection directly. You can add some hot glue for strain relief. You'll still likely have the other side of the connector. If not, who cares, "it just works."
I know it is a pain, and irritating, Prusa wiring is probably the weakest link. I redid pretty much every wire to make them exactly to length and routed properly when building my MK3 because it bugged me.
I would not try to crimp a new terminal properly given your admission of mechanical ability. Getting a good crimp with a small connector is tricky without experience. It would be easier to order the same connector wire precrimped and replace the end of the wire. Then do a splice a few inches higher. Or just order the parts.
If you need to replace a pin on the PCB, it MUST be done carefully or you'll lift a trace. It is a job that should be done with a full soldering station. However I could do it with a candle and a nail in a zombie apocalypse. The trick is in only barely heating the pin enough to melt the solder completely. That requires a soldering iron tip with as much heat mass as possible so that you do not need too much heat to compensate for the temp drop upon contact. If none of this makes sense, just buy the replacement parts.
Sorry for the bad day, seriously.
So, where did the Bambu touch you, can you show us on the doll in front of you? 😀
Come on man, this is a post about a Prusa being f*cked, not an invitation to vent on how you dislike Bambu.
I want my 3d printer to just work and Bambu fills that category just fine. More than fine actually, it (P1S) has been nothing but a pleasure and joy to work with. The quality it produces is mind boggling (to me at least) and it never, ever gives me headaches about hardware or nonsense like that. I do not like to tinker, I want to print and Bambu does that perfectly imo.
In know the history of 3d printing and why I got involved. Bambu changed everything for the worst and forced everyone to lower expectations and business practices. They have been the most toxic community influence to date. Proprietary theft is criminal.
Thanks for that bit of laughter! 😂
You just described the Buggy Whip metaphor pretty darn good.
Guess you liked the matrix printers (or perhaps type writers?) better then these newfangled laser printers with their fancy 'lasers' and whatnots? Not a real question, just a fun tease at your expense.