homeassistant

15359 readers

8 users here now

Home Assistant is open source home automation that puts local control and privacy first.
Powered by a worldwide community of tinkerers and DIY enthusiasts.

Home Assistant can be self-installed on ProxMox, Raspberry Pi, or even purchased pre-installed: Home Assistant: Installation

Discussion of Home-Assistant adjacent topics is absolutely fine, within reason.
If you're not sure, DM @[email protected]

founded 2 years ago

MODERATORS

[email protected]

DreameBot L10s Ultra questions (global.dreametech.com)

submitted 2 years ago by [email protected] to c/[email protected]

10 comments fedilink hide all child comments

I'm thinking of getting a Dreametech L10s Ultra robot vacuum/mop, but have a few remaining concerns/questions that I'm hoping someone who owns an L10s Ultra can help me with.

Can The L10s Ultra handle small bumps? I have a "baseboard" running along the floor between rooms - there's no wall there, just a "separator" in the floor between rooms. It's about 1cm tall and has rounded corners. Will the L10s Ultra be able to move over it?

My house has 3 floors - would I need 3 base stations for the L10s Ultra to clean 3 floors? I know I'll have to pick it up and manually move it between floors, but will it vacuum/mop each floor? If it needs to dump it's dry/wet storage or runs out of battery, with only 1 base station I'll have to pick it up and move it back to the floor with the base station - but will the L10s Ultra be smart enough to know it's on another floor and not try to find it's way back to the basestation (perhaps falling down stairs in the process)?

Have you gone through the rooting process and installed Valetudo? I'd love to have mine run locally only, but the rooting process is very intimidating to me, both the part where I'd need to solder my own PCB and the part of the software process where I'd have only 160 second to do a bunch of stuff or risk bricking my $1000 device. If you've done this process, can you guess whether a noob (never soldered my own PCB, and even my soldering history in general isn't that good) might be capable?

Thanks for your input.

you are viewing a single comment's thread
view the rest of the comments

[–] [email protected] 2 points 2 years ago (1 children)

I was able to flash my Dreame D9 pretty easily. I had to use little wires off of a usb dongle which I got both off of Amazon. It looks like they sell a dongle on the Valetudo site specifically for Dreame devices that might be worth it in your case. https://github.com/Hypfer/valetudo-dreameadapter

I remember coming across a thread somewhere about creating an automaton to replace map files for different floors in your house but I can’t seem to come across it again. You could map each floor, export the file, then restore floor map files as you move the vacuum to other floors.

[–] [email protected] 1 points 2 years ago

Thanks for sharing your experience rooting your D9. The "dongle" that rooting the L10s Ultra seems to require looks like its a bit harder to make. I wonder if any makers out there would make it and sell it to me, and for how much. But there's still the scary 160 seconds.

Your idea for changing floor maps sounds doable, if Home Assistant's automations can push map files to the L10s. I'd hate to have to manually change map files very time I moved the vacuum to another floor